3M Espe Filtek Z250 Xt

Preparation: Clean teeth with pumice and water. Select the appropriate shade by evaluating the tooth's gingival, body, and incisal areas. Use a mock-up to test the shade match. Isolation: Use a rubber dam or cotton rolls with an evacuator for isolation. Direct Restorations: Cavity Preparation: Clean and round cavity; remove residual materials. Pulp Protection: Apply calcium hydroxide and a light-cure glass ionomer liner if needed. Matrix Placement: Use Mylar strips or matrix bands for anterior and posterior restorations. Adhesive System: Follow instructions for etching, priming, and adhesive application. Dispensing: For syringes: Turn the handle clockwise to dispense, then counterclockwise to stop flow and cap the syringe. Placement: Apply composite in increments, overfill slightly, and contour with composite instruments. Curing: Cure each increment with a high-intensity light (400 mW/cm²). Follow recommended exposure times based on shade. Finishing: Contour with fine diamonds or burs. Use finishing strips for proximal surfaces. Adjust Occlusion: Check and adjust occlusion with articulating paper and fine diamonds. Polishing: Polish with the Sof-Lex Finishing and Polishing System. Indirect Procedure: Dental Operatory: Shade Selection: Choose the shade before isolation. Preparation and Impressioning: Prepare tooth and take an impression. Laboratory Procedure: Casting and Trimming: Prepare and trim the cast, apply separating medium. Composite Application: Place die back into the articulated arch; add and slightly overfill with incisal composite. Light cure for 10 seconds, then remove die to avoid sticking. Finish curing. Remove excess composite, develop inclines and ridges. Carefully remove the prosthesis from the die; ensure clean separation from the cured restoration. Check restoration on the master die for fit, flash, and undercuts. Adjust and polish as needed. Dental Operatory Procedure: Roughen the interior surfaces of the indirect restoration. Clean the prosthesis in a soap solution using an ultrasonic bath and rinse thoroughly. Cement the prosthesis using a 3M ESPE resin cement system, following the manufacturer’s instructions

Easy to sculpt and holds its shape prior to cure Handles better than other nanohybrid composites Does not slump Does not stick to the composite instruments hence is easy to adapt Predictable esthetics High stregth Good wear resistance

Pack of 1

1.Service and Warranty are handled by the manufacturer/importer directly for this product 2. Any or all claims in relation to returns and replacement shall be made to the concerned Manufacturer/Importer only and meddent.in may assist the customer in registering a request to get the Product replaced or serviced. 3.meddent.in will not be liable to replace the Products and the liability to replace any such Product is that of the Manufacturer/Importer 4.The Buyer acknowledges that the Products once sold will not be exchanged or taken back unless the seal of the package or the Product is intact or not altered in any manner or is not tampered as the case may be.